In fact, if you choose to install a single sink vanity or double, the most important factor is the actual size of your bathroom. Although you want to get more sinks , but if it does not fit your actual bathroom size, your bathroom space will be narrow. In order to get a relaxing and comfortable space, a single sink vanity is your ideal option.
Reasons for Single Sink Vanity
1. Leave space for other facilities.
If your bathroom space is small, this is an issue you must consider. If you have enough space, but you have other plans, please choose a single sink. Of course, you can find china luxary double sink vanity online for your huge bathroom.
2. Cost and cleanliness.
One sink and one hardware set are cheaper than two, and one sink is easier to clean than two sinks.
3. More storage space.
If there is only one drain, you can have more storage space underneath. If you are the kind of person who likes to pump out a little makeup, you will feel frustrated if there is not enough space because of that extra sink.
Choose single sink vanity factory china
Wash basin: artificial stone basin
It is featured by Waterproof, multifunctional storage, High-quality hinges, Moisture-proof.
Single Sink Vanity Installation
Single Sink Vanity
When you get a single sink vanity, please follow the following installation steps.
- Check the reserved water supply and drainage pipes, and install the steel bracket to support the washbasin countertop.
- According to the cutting diagram of the countertop in the packing box of the under counter basin, polish the opening of the countertop.
- According to the installed faucet and table size, cut the faucet installation hole correctly and polish it.
- Temporarily put the wash basin into the opening of the installed countertop, check the gap, and make a mark.
- After checking and verifying, put the washbasin flat, apply silicone sealing material on the upper edge of the washbasin, carefully put the washbasin under the counter top, align it with the installation hole, align it with the previous mark and press it upwards , And use the connection Invar conductor between the washbasin and the counter top provided by the manufacturer to tightly connect the washbasin and the counter top.
- Glue the edge of the undercounter basin.
- Install the upper and lower hardware of the under-counter basin.
- After the sealant has hardened, connect the water inlet and drain pipe fittings.
Matters needing attention
When installing a washbasin with a pipe rack, draw a vertical line according to the middle of the drain pipe opening, measure the specified height from the ground up, and draw a horizontal line on the wall.
- Draw a mark on the wall according to the width of the washbasin.
- Before inserting the expansion bolt, clean up the impurities in the hole.
- When installing the nut, pay attention to tightening and firmness.
- The edge glue must be dense and not leaking.
- If the wash basin cannot be balanced, you can put a ruler on the basin surface to correct the balance.
- Handle with care when installing the washbasin.
Single sink vanity or double sink vanity, consider your bathroom size first. Then, take every your idea into the consideration, including enough room space for other uses, you needs, finally, make your final decision.
