The faucet or Basin Mixer  is the first step to turn on the water source. If the faucet is not properly maintained, the effect will be very poor and bring inconvenience to you. There are many mixers at home, including basin mixer, bathtub faucet, kitchen faucet, etc.

Wall-mounted shower and bathtub faucet

wall mounted thermostatic mixer wholesale

After you have purchased a shower, bathtub, or wall-mounted faucet, you can choose a suitable height to bury the water pipe. The distance between the hot and cold water pipes must reach 15 work points. Before installation, you must not forget to flush the water pipe to prevent the water from being too hard and causing damage to the faucet. If the elbow between the faucet and the wall joint is too long, you can cut off a part of the 4-point wire. Remember: the 6-point wire connected to the faucet does not seem to be cut randomly.

Concealed shower and bathtub faucet

Basin Mixer

After purchasing a concealed faucet, the valve core of the faucet is generally pre-buried in the wall. Be sure to pay attention to the thickness of the bathroom wall before embedding. If the wall is too thin, the spool will not be embedded. Do not remove the plastic protective cover of the valve core easily when embedding, so as not to damage the valve core due to cement and other chores. In addition, you should pay attention to the up and down, left and right directions of the spool when embedding the spool, so as not to embed the spool incorrectly.

Basin mixer

Most of the basin faucets are hard pipe water inlets, so you should pay attention to the height of the upper nozzle. It is most suitable to go down from the basin to 35 work points. During installation, and the angle valve must be fixed to the hot and cold water pipes out of the wall. When you find that there is a distance between the angle valve and the water pipe on the faucet, go to your store at the time to purchase a special extension pipe for the mixer to connect it.

Remember, you must not use other water pipes to connect, because if the water pressure is high, it will easily fall off and Anti-termite Cable leak water, causing you loss. If the inlet pipe is too long to exceed the outlet pipe, the part can be cut off according to your needs. If the angle is not suitable, you can bend it to the position you need.

Don’t bend to 90 degrees or more than hard. When installing the basin to drain, please do not forget to purchase the small connector of the faucet (short-circuit the faucet).

Hand wash basin mixer

When buying a single-handle basin mixer, you should pay attention to the diameter of the spout.

Thermostatic faucet

thermostatic shower

Before installing the thermostatic faucet, please check whether the water pipes are hot on the left and cold on the other. Remember not to connect the hot and cold water pipes wrongly to prevent the faucet from not working properly. Gas and solar water heaters cannot use thermostatic faucets because the water pressure is too low. Don’t forget to install the hot and cold water filter when installing the thermostatic faucet.

At the same time, in addition to different cleaning and maintenance methods for different faucets, there is also a common method of using stainless steel. For example, in the process of using the faucet, it is necessary to frequently maintain and clean the scale on the surface of the faucet and the water sand in the faucet to protect The chrome layer on the surface of the mixer is as bright as new. Do not use rough towels and cloths to wipe the faucet, so as not to scratch the chrome layer, and do not touch the faucet with acid or alkaline materials to avoid destroying its brightness.

Hope these maintenance tips can help you.?